Access Covers Australia manufactures access covers and grates to all seven AS 3996 load classes, from Class A to Class G, according to load capacity as set out in the table below
Testing of covers and grates shall be in accordance with AS 3996. The appropriate class for a cover or grate depends upon the location of the installation. The selection of the appropriate class is the responsibility of the designer, and where there is doubt, the stronger class shall be selected.
Specifics of the location should be taken into consideration when selecting the right cover or grate. The speed of traffic, wheel type and the physical position (turning area) should all be assessed.

Reference: AS3996:2019 – Standards Australia
What is AS 3996?
AS 3996:2019 is the Australian Standard for access covers and grates. The AS 3996 load classes run from Class A for pedestrian areas to Class G for ports and airports, and the standard specifies how covers and grates must be tested to prove they can carry their rated load safely.
How to choose the right load class
The right load class depends on the heaviest load that could ever travel over the cover or grate, not just the traffic you expect day to day. Under AS 3996, choosing the class is the designer’s responsibility, and if you’re in any doubt, you should always choose the stronger class. A cover that’s under-rated can crack, rock or collapse, creating a serious safety risk and an expensive replacement.
Start with the heaviest vehicle that could use the area. A footpath may only see pedestrians most of the time, but if a council truck, delivery van or garbage truck could ever drive or park on it, the cover needs to be rated for that vehicle. Think about access during construction, maintenance and emergencies too, not just normal use.
Also, consider how vehicles move over the cover. Covers in turning areas, at intersections, on ramps or near loading bays take extra force from braking, accelerating and turning wheels. Fast-moving traffic also adds impact loads. Covers in these positions often need a higher class than the vehicle weight alone suggests.
AS 3996 load classes table
| Class | Typical Use | Nominal Wheel Loading (kg) |
Serviceability Design Load (kN) |
Ultimate Limit State Design Load (kN) |
Vehicle type |
|---|---|---|---|---|---|
| A | Areas (including footways) accessible only to pedestrians and pedal cyclists, closed to other traffic (extra-light duty). | 330kg | 6.7kN | 10kN | Pedestrians and cyclists |
| B | Areas (including footways and light tractor paths) accessible to vehicles (excluding commercial vehicles) or livestock (light duty). | 2,670kg | 53kN | 80kN | Light tractors and livestock |
| C | Malls and areas open to slow-moving commercial vehicles (medium duty). | 5,000kg | 100kN | 150kN | Slow-moving commercial vehicles |
| D | Carriageways of roads and areas open to commercial vehicles (heavy duty). | 8,000kg | 160kN | 240kN | Commercial vehicles and roads |
| E | General docks and aircraft pavements (extra heavy duty – E). | 13,700kg | 267kN | 400kN | Docks and aircraft pavements |
| F | Docks and aircraft pavements subject to high wheel loads (extra heavy duty – F). | 20,000kg | 400kN | 600kN | High wheel loads, docks |
| G | Docks and aircraft pavements subject to very high wheel loads (extra heavy duty – G). | 30,000kg | 600kN | 900kN | Very high wheel loads, aircraft |
Notes:
- Nominal wheel loads are given for guidance only. Consideration should be given to the type, size and pneumatic pressure of the load
- Class B design loads exceed AS 5100.2 requirements for footway
- Class D design loads exceed AS 2 requirements for a W80 wheel load.
- Class C units are based on an intermediate
- The serviceability load is set at 2/3 of the ultimate limit state design load.
- A force of 1 kN approximately equal to the weight of 100 kg.
View our extensive range of Access Covers.
View our extensive range of Grates.
These are general guides only. Every site is different, so if your project involves heavy vehicles, forklifts, turning traffic or anything unusual, talk to our engineering team before you specify. Call (03) 9335 5355 or send us your plans, and we’ll recommend the right class for each location.